|
|
 |
NEWS |
|
Vehicle deviation, check the tire tread, the chassis is not normal wear and tear is too large a gap
|
| Release time：2014.04.25 News source：Taizhou Skuch Auto Parts Co.,Ltd.tie rod end,rack end,ball joint,stabilizer link,drag link Browsing number： |
| |
It is reported that Yunnan Yi Yi Chery Automobile 4S shop maintenance manager Fu Xiaobo told reporters, resulting in the car, there are many reasons for the deviation, such as tire pressure is inconsistent, the degree of tread wear is not the same, chassis parts wear too big a gap, such as the presence of abnormal so will cause the vehicle deviation. He said: "The wheel alignment deviation allowed is a common cause of vehicles, such as front wheel camber, kingpin angle is not correct, or the toe angle is too small, also will result in deviation but the reason is not a panacea. So when the owner of the vehicle during the test, you should first of all parts of the vehicle for testing. "
Both sides of the tire pressure
According to ex-hung ball joint understanding, Fu Xiaobo told reporters, ranging from tire pressure deviation leading to more serious car for a reason. Because tire pressure ranging from tires will become sample sizes, so when the car will roll up deviation. He said: "If the owners to make better use of the tire, the proposed exchange about twenty thousand kilometers per tire position, because the degree of wear of the drive wheel will always be larger than the other wheels, friction will directly lead to different deviation." He said the correct tire replacement method is to swap the front and rear pairs of children at the same time, you can not cross the diagonal swap back and forth. In addition, if the owner needs to get a new tire, you should choose to replace the same brand of tire tread, but it is best to replace the four tires simultaneously.
Tire tread
fu xiao bo said tread is not the same on both sides of the vehicle or a deep one shallow pattern is not as high, can easily lead to vehicle deviation. The owner of the vehicle in order to avoid the occurrence of deviation, then the use of the vehicle, the owner is best to let all cars use the same type of tire, at least to the front axle and the rear axle of the two tires must be the same, but the pattern depth must be the same. Meanwhile, if the tire wear over the limit, it must be promptly replaced.
Chassis is not normal wear and tear is too large a gap exists
"Vehicle chassis components is not normal wear and tear is too large a gap exists, is one of the reasons for the deviation of the lead vehicle." Fu Xiaobo told reporters. Among them, the steering rod ball joint, the support arm pouches, pouches, etc. are common stabilizer bar gap is too large and easy site owners at the time of vehicle maintenance, careful examination of the full range of vehicles to deal with.
He said, steering system will also affect the quality of the car driving straight. Each connector gap is too large due to wear or bearing, kingpin, bushing wear causing loose, causing the car to swing in motion, can not maintain a normal trajectory. If the steering arm, knuckle bent, usually caused by car-way deviation.
|
|
|
|
