According to Commerce Department requirements, organized by the China Automotive Technology and Research Center drafted the " junk car crushing technical specifications" industry standards and draft released for public comment yesterday , the deadline for comments is May 30, 2014 . Develop technical specifications proposed broken car is scrapped after sorting comprehensive recovery of renewable resources will not be less than 90%.

Well , according to David drag link noted , in the future , car scrap crushing plant should not be located in drinking water source protection areas, basic farmland protection areas or other areas that need special protection , job site area of ​​not less than 20,000 square meters and is equipped with the sewerage and drainage ditch , water separator , such as sewage treatment plant. The remaining material by sorting or manual sorting equipment , obtained after crushing junk cars will include stainless steel , wire , rubber, plastic and other recyclable materials.

Data show that China's 2011 civilian car ownership has exceeded 100 million , more than four million scrap car , scrap car 2020 the number will be over 14 million . Scrap cars contain a lot of harmful substances such as lead, mercury, cadmium , polybrominated biphenyls and polybrominated diphenyl ethers , etc. These materials are widely used in automotive steel, glass , brakes , electronics, leather , coatings and other components or materials . The proposed junk car crushing technical specifications, designed to raise barriers to entry , and guide enterprises in the scrap car recycling and reuse of materials separation to enhance environmental protection and other aspects of the job level.

   Registered motor vehicles of the following circumstances shall the mandatory retirement : to reach the vehicle 's useful life ; still not been repaired and adjusted in line with national standards for vehicle safety and technical requirements related to the car 's ; adjusted or repaired and after the use of control technology , discharge of pollutants into the atmosphere or noise is still in line with the national standards of the relevant requirements in the car ; inspection after the expiry of validity has not obtained within three consecutive test cycles motor vehicle inspection mark .

Meanwhile, near the mandatory retirement age of less than 1 year of motor vehicles, shall not apply to change the nature of the use , transfer of registration and registration of vehicle management managed to move out of the area and other services. In strict accordance with the new requirements, for three consecutive cycles without obtaining inspection marks of vehicles will be mandatory retirement , and urge the vehicle owner for cancellation of registration services.

Well hung drag link reminded owners : Motor vehicles shall from the date of registration , the following inspection cycle safety and technical inspection : commercial passenger vehicles within 5 years inspection once a year ; over five years , every six months test 1 . Trucks and large and medium-sized non- commercial passenger vehicles less than 10 years of inspection once a year ; over 10 years , every 6 months Inspection 1. Small , micro non- commercial passenger vehicles less than 6 years of inspection once every two years. More than six years , the annual inspection of a second ; over 15 years , every six months test 1 ; motorcycle inspection within four years once every two years ; over four years , the annual inspection 1. Tractors and other motor vehicle inspection once a year.